Forester AWD F4-2.5L DOHC (1998)
3. Remove snap ring, then disconnect gearshift lever from stay.
4. Remove boot from gearshift lever.
5. Remove 0-ring, then disconnect bush (Stay rear).
6. Draw out spring pin, then remove bush (Shift lever) from gearshift lever.
C: INSPECTION
Check each parts (Bush, cushion, spacer, boot, spring, stay and rod etc.) for deformation, damage and wear. Repair or replace any defective parts.
Determine defective parts by comparing with new parts.
D: ASSEMBLY
1. Clean all parts before assembly.