Forester S F4-2.5L DOHC (1998)
1) Apply fluid packing sparingly to cap mating surface.
CAUTION: Do not apply fluid packing excessively. Failure to do so may cause excess packing to come out and flow toward oil seal,
resulting in oil leaks.
Fluid packing: THREE BOND 1215 or equivalent
2) Apply engine oil to cap bearing surface and install cap on camshaft as shown by identification mark.
Intake Camshaft Cap Bolts Tightening Sequence; Tighten Exhaust Camshaft Cap Bolts Similarly
3) Gradually tighten cap in at least two stages in alphabetical sequence shown in figure, and then tighten to specified torque.
4) Similarly, tighten cap on exhaust side.
After tightening cap, ensure camshaft rotates only slightly while holding it at "base" circle.
3) Camshaft oil seal installation.
Apply grease to new oil seal lips and press onto front end of camshaft by using ST1 and ST2.
CAUTION: Use a new oil seal.
ST1 499587100 OIL SEAL INSTALLER
ST2 499597000 OIL SEAL GUIDE
4) Rocker cover installation
1) Install gasket on rocker cover.
Install peripheral gasket and ignition coil gasket.
