Forester S F4-2.5L DOHC (1998)
CHECK: Does the airbag warning light come off?
YES:
Go to step 5O4.
NO:
Go to step 5O3.
5O3: INSPECTION OF BODY HARNESS
Check body harness.
NOTE: After problem has been eliminated, disconnect connectors (3A) and (4A).
CHECK: Is there anything unusual to body harness?
YES:
Repair body harness.
NO:
Replace airbag warning light bulb or combination meter printed circuit.
5O4: CHECK POOR CONTACT IN CONNECTOR (AB6).
Check connector (AB6) connected to airbag control module.
CHECK: Is there poor contact in connector (AB6)?
YES:
Repair poor contact in connector (AB6).
NO:
Go to step 5O5.
5O5: INSPECTION OF AIRBAG MAIN HARNESS
1. Turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20 seconds, and re-conned connectors (AB1) and (B31).
2. Remove instrument panel lower cover and disconnect (AB3) with (AB8), then disconnect connector (AB6) from airbag control module, and
connect it to test harness E connector (1E).
3. Connect battery ground cable and turn ignition switch "ON", (engine off) and connect connectors (4E) and (5E).
NOTE: After problem has been eliminated, disconnect connectors (4E) and (5E).
CHECK: Does the airbag warning light come on?
YES:
Go to step 5O6.
NO:
Replace airbag main harness.