Forester S F4-2.5L DOHC (1998)
2. Press out bearing together with backing washer using pipe of I.D. 38.5 to 39.5 mm (1.516 to 1.555 inch) and press.
CAUTION: Do not reuse removed bearing.
3. Remove oil seal.
CAUTION: Do not reuse removed oil seal.
4. Put vinyl tape around pinion shaft splines to protect oil seal from damage.
5. Fit pinion and valve assembly into valve housing.
NOTE: Apply specified power steering fluid to outer diameter surface of input shaft and outer surface of valve body seal ring, and pay special
attention not to damage seal when inserting pinion and valve assembly.
6. Secure valve assembly to ST1 and ST2.
7. Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
NOTE:
-
Apply specified power steering fluid to oil seal and ST3, being careful not to damage oil seal lip.
