Forester S F4-2.5L DOHC (1998)
1. Check the bearing for smooth movement by applying force in the radial direction.
Radial direction stroke:
1.4 mm (0.055 inch)
2. Check the bearing for smooth rotation by applying pressure in the thrust direction.
3. Check wear and damage of bearing case surface contacting with lever.
2. Release Lever
1. Check lever pivot portion and the point of contact with release bearing case for wear.
C: INSTALLATION
CAUTION: Before or during assembling, lubricate the following points with a light coat of grease.
^
Inner groove of release bearing
^
Contact surface of lever and pivot
^
Contact surface of lever and bearing
^
Transmission main shaft spline (Use grease containing molybdenum disulfide.)
1. While pushing release lever to pivot and twisting it to both sides, fit retainer spring onto the constricted portion of pivot.
NOTE:
-
Apply grease (SUNLIGHT 2: P/N 003602010) to contact point of release lever and operating cylinder.
-
Confirm that retainer spring is securely fitted by observing it through the main case hole.
2. Install release bearing and fasten it with two clips.
3. Install release lever seal.
