Forester S F4-2.5L DOHC (1998)
-
Be sure to replace oil seal at every overhaul.
ASSEMBLY
1. Attach hub to ST securely.
ST 927080000 HUB STAND
2. Using a hydraulic press, press new hub bolts into place.
CAUTION: Be sure to press hub bolts until their seating surfaces contact the hub.
NOTE: Use 12 mm (0.47 inch) dia. holes in HUB STAND to prevent bolts from tilting.
3. Remove foreign particles (dust, rust, etc.) from mating surfaces of hub and tone wheel, and install tone wheel to hub (only vehicle equipped with
ABS).
CAUTION:
-
Be careful not to damage tone wheel teeth.
-
Ensure tone wheel closely contacts hub.
4. Clean dust or foreign particles from inside the housing.
5. Using ST1 and ST2, press a new bearing into place.
ST1 927400000 HOUSING STAND
ST2 927100000 BEARING REMOVER
CAUTION:
-
Always press outer race when installing bearing.
-
Be careful not to remove plastic lock from inner race when installing bearing.
-
Charge bearing with new grease when outer race is not removed.
6. Install snap ring in its groove.