Subaru Workshop Manuals
Hatchback 4WD F4-1781cc 1.8L (1983)
Brakes and Traction Control > Parking Brake System > Parking Brake Warning Lamp > Component Information > Diagrams > Diagram Information and Instructions > Page 1891
Fig. 9 Completing the Crimp
Step 4: Crimp the Wires
Select the proper clip to secure the splice. To determine the proper clip size for the wire being spliced, follow the directions included in the J
Open the crimping tool to its full width and rest one handle on a firm flat surface.
Center the back of the splice clip on the proper anvil and close the crimping tool to the point where the former touches the wings of the clip.
Make sure that the clip and wires are still in the correct position. Then, apply steady pressure until the crimping tool closes, Fig. 8.
Before crimping the ends of the clip, be sure that:
The wires extend beyond the clip in each direction.
No strands of wire are cut loose, and
No insulation is caught under the clip. Crimp the splice again, once on each end. Do not let the crimping tool extend beyond the edge of the
Step 5: Solder
Apply 60/40 rosin core solder to the opening in the back of the clip, Fig. 10.
|[PREV PAGE] [NEXT PAGE]|