Subaru Workshop Manuals
Hatchback 4WD F4-1781cc 1.8L (1983)
Instrument Panel, Gauges and Warning Indicators > Brake Warning Indicator > Component Information > Diagrams > Diagram Information and Instructions > Page 2465
Follow the steps below to repair Weather Pack(R) connectors, Fig. 21.
Separate the connector halves.
Open secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector.
Grasp the lead and push the terminal to the forward most position. Hold the lead at this position.
Insert the Weather Pack(R) terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder.
Gently pull on the lead to remove the terminal through the back of the connector.
NOTE: Never use force to remove a terminal from a connector.
Inspect the terminal and connector for damage. Repair as necessary, see TERMINAL REPAIR.
Reform the lock tang and reseat terminal in connector body.
Close secondary locks and join connector halves.
Splicing Copper Wire Using Crimp and Seal Splice Sleeves
Crimp and Seal splice sleeves may be used on all types of insulation except tefzel and coaxial to form a one to one splice. They are to be used where
Step 1: Open the Harness
If the harness is taped, remove the tape. To avoid wire insulation damage, use a sewing "seam ripper" to cut open the harness (available from
Step 2: Cut the Wire
Begin by cutting as little wire off the harness as possible. You may need the extra length of wire later if you decide to cut more wire to change the
Fig. 6 Wire Size Conversion Table
Step 3: Strip the Insulation
If it is necessary to add a length of wire to the existing harness, be certain to use the same size as the original wire, see Fig. 6.
|[PREV PAGE] [NEXT PAGE]|