Subaru Workshop Manuals
Hatchback 4WD F4-1781cc 1.8L (1983)
Powertrain Management > Fuel Delivery and Air Induction > Throttle Cable/Linkage > Component Information > Technical Service Bulletins > Recalls for Throttle Cable/Linkage: > HCC33 > Nov > 84 > Recall - Accelerator Cable > Page 1434
Check the driver's door "B" pillar for the presence of an HCC-33 recall completion sticker (See Figure 4). If the sticker is present then no action is
Check the position of the protective sleeves at location A and B of the accelerator cable. (See Figure 5). If the sleeves are in position proceed to
Install a securing clamp (P/N SPS 053 160) at locations A and B as illustrated in Figure 5.
REPLACEMENT is necessary. Use a modified cable (P/N SPS 065 311), while keeping in mind the precautions listed below.
Do not kink the cable at positions "A" or "B" (See Figure 5) of the accelerator cable.
Do not twist the cable.
Tighten the nut at "A" position on the link assembly. Positioning it 0.4 in. from the cable end. (See Figure 6).
Properly fill out the recall completion sticker and attach it to the driver's door "B" pillar. (See Figure 4).
THE REPLACEMENT OPERATION IS WARRANTABLE UNDER OPERATION # 149-331 AND ALLOWS 0.7 HRS. FAILURE CODE SFC-77.
Owner Notification Letter
Dear Subaru Owner:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Subaru of America, Inc. has determined that a defect which relates to motor vehicle safety exists in some 1982 through 1984 Model Year Subaru
|[PREV PAGE] [NEXT PAGE]|