Impreza F4-2.5L SOHC (2003)
replaced to ensure consistent appearance.
Tools and parts kit required:
^
Electrical drill
^
Hole saw tap or drill bit (22 mm in diameter)
^
Drill bit (3.3 mm)
^
File
^
Rivet gun
^
Water paint marker
^
Nox Rust or equivalent anti-rust protection
^
Touch-up paint
^
Bolt to temporarily hold the Nut Plate (8 mm in diameter and 25 mm or longer) [The spare tire holder can be used as a substitute for a bolt.]
^
Stay RG (Rear Gate) Kit (P/No.: 63269FE210)
^
Vacuum cleaner
Replacement procedure:
Note:
Only replace one rear gate stay and related hardware at a time. Do not attempt to separate the stud bolts from the gate stay. The Stay will be
permanently damaged if an attempt is made to disconnect it from the Stud Bolt.
(a)
Support the tailgate in the full upright position by using a suitable devise such as an adjustable jack stand.
(b)
Using a 12 mm open end wrench, remove the rear gate stay by unfastening both the upper and lower stay stud bolts.
Note:
On some models it will be necessary to remove the lower trim panel found around the lower stud bolt.