Impreza 2.5 RS Coupe F4-2.5L SOHC (2000)
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When terminal No. 3 or No. 6 are separated from diagnosis terminals. (When select monitor is not used.)
3. When the brake pedal is released during sequence control and the braking lamp switch is set to off.
4. When brake pedal is depressed after ignition key is turned to ON, and before ABS warning light goes out. (When select monitor is not used.)
5. When brake pedal is not depressed after ignition key is turned to ON, and within 0.5 seconds after ABS warning light goes out. (When select
monitor is not used.)
6. After completion of the sequence control.
7. When malfunction is detected. (When select monitor is used.)
Conditions For ABS Sequence Control
NOTE:
-
When select monitor is used, control operation starts at point A. The patterns from IGN key ON to the point A show that operation is started by
diagnosis connector.
-
HIGH means high voltage.
-
LOW means low voltage.
E: INSTALLATION
1. Install ABSCM&H/U.
CAUTION: Confirm that the specifications of the ABSCM&H/U conforms to the vehicle specifications.
Tightening torque: 18 ± 5 Nm (1.8 ± 0.5 kg-m, 13.0 ± 3.6 ft. lbs.)