subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Pedal Effort Reducing Mechanism|Page 3546 > < Pedal Effort Reducing Mechanism|Page 3544
Page 2
background image

Check pedal stroke and free play by operating accelerator pedal by hand. If it is not within specified value, adjust it by turning nut connecting
accelerator cable to throttle body.
Free play at pedal pad: L 1 - 4 mm (0.04 - 0.16 inch) 
Stroke at pedal pad: A 50 - 55 mm (1.97 - 2.17 inch) 
Accelerator cable lock nut tightening torque: 14 ± 4 Nm (1.4 ± 0.4 kg-m, 10.1 ± 2.9 ft. lbs.) 

CLUTCH PEDAL 

1) Push release fork until operating cylinder push rod retracts. Check that clutch fluid level in reservoir tank increases.
2) If clutch fluid level increases, hydraulic clutch play is correct.
3) If clutch fluid level does not increase or push rod does not retract, clutch pedal must be adjusted. <Ref. to 4-5 [W1F1].>
4) Check the fluid level on the outside of the clutch master cylinder tank. If the level is below "MIN", add clutch fluid to bring it up to "MAX".

Recommended clutch fluid: FMVSS No. 116, fresh DOT 3 or DOT 4 brake fluid

REMOVAL 

ACCELERATOR PEDAL 
1) Disconnect ground cable from battery.
2) Disconnect accelerator cable from throttle body.

CAUTION: Be careful not to kink accelerator cable.

3) Remove instrument panel lower cover from instrument panel, and connector.

Pedal Effort Reducing Mechanism|Page 3546 > < Pedal Effort Reducing Mechanism|Page 3544