subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 4402 > < Symptom Related Diagnostic Procedures|Page 4400
Page 6
background image

-

Front sub sensor harness (LH) circuit is open.

-

Front sub sensor (LH) is faulty.

-

Airbag control module is faulty.

CAUTION:  Before performing diagnostics on airbag system, turn ignition switch "OFF", disconnect battery ground terminal, and then wait at least 20
seconds
.

5L1: FRONT SUB SENSOR (LH) AND FRONT SUB SENSOR HARNESS (LH) INSPECTION

1. Disconnect connector (AB6) from airbag control module, and connect it to test harness I or I2 connector (1I).

2. Measure resistance between test harness I or I2 connector (3I) terminal.

CHECK: Is the resistance between 750 Ohms and 1 k-Ohms?

YES:

Replace airbag control module. 

NO:

Go to step 5L2.

5L2: FRONT SUB SENSOR (LH) AND FRONT SUB SENSOR HARNESS (LH) INSPECTION

Measure resistance across test harness I or I2 connector (3I) terminal and chassis ground.

CHECK: Is the resistance more than 10 k-Ohms?

YES:

Replace airbag control module. 

NO:

Go to step 5L3.

5L3: FRONT SUB SENSOR (LH) AND FRONT SUB SENSOR HARNESS (LH) INSPECTION

Measure resistance across test harness I or I2 connector (3I) terminal and chassis ground.

Symptom Related Diagnostic Procedures|Page 4402 > < Symptom Related Diagnostic Procedures|Page 4400