Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
4. Remove two bolts and four nuts which secure brake pedal to pedal.
INSTALLATION
1. Install in the reverse order of removal.
CAUTION:
-
If cable clamp is damaged, replace it with a new one.
-
Never fail to cover outer cable end with boot.
-
Be careful not to kink accelerator cable.
-
Always use new clevis pins.
2. Adjustment of clutch pedal
3. Adjustment after pedal installation.
ASSEMBLY
1. Attach stop light switch, etc. to pedal bracket temporarily.
2. Clean inside of bores of clutch pedal and brake pedal, apply grease, and set bushings into bores.
3. Align bores of pedal bracket, clutch pedal and brake pedal, attach brake pedal return spring and clutch pedal effort reducing spring, and then
install pedal bolt.
NOTE: Clean up inside of bushings and apply grease before installing spacer.
4. Set brake pedal position by adjusting position of stop light switch.
Pedal position: L
125.9 mm (4.96 inch)
Tightening torque:
T1: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)