Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
INSTALLATION
1. Install disc rotor on hub.
2. Install support on back plate.
Tightening torque: 52 Nm (5.3 kgf-m, 38.3 ft. lbs.)
CAUTION:
-
Always replace the pads for both the left and right wheels at the same time. Also replace pad clips if they are twisted or worn.
-
A wear indicator is provided on the inner disc brake pad. If the pad wears down to such an extent that the end of the wear indicator contacts the
disc rotor, a squeaking sound is produced as the wheel rotates. If this sound is heard, replace the pad.
-
Replace pads if there is oil or grease on them.
3. Apply thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad clip.
4. Install pads on support.
5. Install caliper body on support.
Tightening torque: 20 Nm (2.0 kgf-m, 14.5 ft. lbs.)
6. Connect brake hose.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
CAUTION:
-
The brake hose must be connected without any twist.
-
Replace brake hose gaskets with new ones.
7. Bleed air from brake system.