Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
CAUTION: Record the direction of lever before removing.
7. Remove overrunning clutch from shaft assembly as follows:
1. Remove stopper from ring by lightly tapping a fit tool placed on stopper.
2. Remove ring, stopper and clutch from shaft.
8. Slightly open the metal fitting holding the insulating plate to the brush holder. Remove the insulating plate.
NOTE: The brush and spring can be easily removed from the brush holder at this time.
ASSEMBLY
Assembly is in the reverse order of disassembly. Observe the following:
1. Carefully assemble all parts in the order of assembly and occasionally inspect nothing has been overlooked.
2. Apply grease to the following parts during assembly.
-
Front bracket sleeve bearing
-
Armature shaft gear
-
Outer periphery of plunger
-
Mating surface of plunger and lever
-
Gear shaft splines
-
Mating surface of lever and clutch
-
Ball at the armature shaft end
-
Internal and planetary gears
3. After assembling parts correctly, check to be sure starter operates properly.