subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Power Steering Line/Hose|Service and Repair|Page 4198 > < Warranty - Mandatory Replacement Fluids|Page 4194
Page 1
background image

Power Steering Line/Hose: Service and Repair

REMOVAL 

1. Disconnect battery minus terminal.

2. Lift vehicle and remove jack-up plate.

3. Remove one pipe joint at the center of gearbox, and connect vinyl hose to pipe and joint. Discharge fluid by turning steering wheel fully clockwise

and counterclockwise. Discharge fluid similarly from the other pipe.

CAUTION:  Improper removal and installation of parts often causes fluid leak trouble. To prevent this, clean the surrounding portions before
disassembly and reassembly, and pay special attention to keep dirt and other foreign matter from mating surfaces.

4. Remove clamp E from pipes C and D.

5. Disconnect Pipe C from pipe (on the gearbox side).

CAUTION: 

Power Steering Line/Hose|Service and Repair|Page 4198 > < Warranty - Mandatory Replacement Fluids|Page 4194