Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
Trailing Arm: Service and Repair
REMOVAL
1. Loosen rear wheel nuts.
2. Jack-up vehicle, support it with safety stands (rigid racks) and remove rear wheels.
3. Remove both rear parking brake clamp and ABS sensor harness. (only vehicle equipped with ABS)
4. Remove bolt which secure trailing link to trailing link bracket.
5. Remove bolt which secure trailing link to rear housing.
INSTALLATION
Install in the reverse order of removal.
CAUTION: Always tighten rubber bushing location when wheels are in full contact with the ground and vehicle is at curb weight condition.
NOTE: Check wheel alignment and adjust if necessary.
DISASSEMBLY
Front Bushing
Using ST, press front bushing out of place.
ST 927720000 INSTALLER & REMOVER SET
Rear Bushing