Impreza 2.5 RS Coupe AWD F4-2.5L SOHC (2001)
9. Remove DOJ from rear differential using tire lever. (2200 cc AT vehicles)
NOTE: The side spline shaft circlip comes out together with the shaft.
CAUTION: When removing the DOJ from the rear differential, fit tire lever to the bolt as shown in figure so as not to damage the axle shaft
holder.
10. Remove axle nut and drive shaft. If it is hard to remove, use ST1 and ST2.
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 PLATE
CAUTION:
^
Be careful not to damage oil seal lip when removing rear drive shaft.
^
When rear drive shaft is to be replaced, also replace inner oil seal with a new one.
B: INSTALLATION
1. Insert BJ into rear housing splines.
CAUTION: Be careful not to damage inner oil seal lip.
2. Using ST1 and ST2, pull drive shaft into place.
