Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
^
Always use a vertical type pressing tool to move the adjuster rod down.
^
Do not use a lateral type vise.
^
Push the adjuster rod vertically.
^
Press-in the push adjuster rod gradually taking more than three minutes.
^
Do not allow press pressure to exceed 9,807 N (1,000 kgf, 2,205 lbs.).
^
Press the adjuster rod as far as the end surface of the cylinder. Do not press the adjuster rod into the cylinder. Doing so may damage the
cylinder.
4. Measure the extension of rod beyond the body. If it is not within specifications, replace with a new one.
Rod extension: H 5.7 ±0.5 mm (0.224 ±0.020 inch)
3. BELT TENSION PULLEY
1. Check the mating surfaces of timing belt and contact point of adjuster rod for abnormal wear or scratches. Replace the automatic belt tension
adjuster assembly if faulty.
2. Check the tension pulley for smooth rotation. Replace if noise or excessive play is noted.
3. Check the tension pulley for grease leakage.
4. BELT IDLER
1. Check the belt idler for smooth rotation. Replace if noise or excessive play is noted.
2. Check the belt outer contacting surfaces of idler pulley for abnormal wear and scratches.
3. Check the belt idler for grease leakage.
