Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Seat Belt: Service and Repair
Front Seat Belt
Outer Belt
OUTER BELT (FRONT)
REMOVAL
1. Fold backrest all the way forward, and then move the front seat all the way forward.
2. Turn the ignition switch OFF, disconnect the ground cable from battery, and wait for more than 20 seconds before starting work.
3. Remove the center pillar lower trim.
4. Remove the anchor cover. Loosen the shoulder anchor bolt, and then detach the shoulder anchor from center pillar.
5. Turn over the floor mat to remove the bolts.
6. Disconnect the yellow connector of pretensioner harness, and remove the outer belt (front).
CAUTION: Do not drop or apply any impact to the pretensioner.
Pretensioner and bracket should be treated as an assembly. Do not attempt to disassemble it.
INSTALLATION
Install in the reverse order of removal.
CAUTION: The parts on right and left are not identical. Before installation, make sure that the correct part is used.
Be careful not to twist the belts during installation.
Inner Belt
INNER BELT (FRONT)
REMOVAL
1. Disconnect the connector.
