Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
8. Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
NOTE:
^
Apply the specified power steering fluid to the oil seal and ST3, being careful not to damage oil seal lip.
^
Push the oil seal until ST3 contacts housing end face.
9. Remove ST3, and fit backing washer.
10. Force-fit ball bearing using ST3.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 927640000 INSTALLER B
NOTE: Be careful not to tilt ball bearing during installation.
11. Install the snap ring using snap ring pliers.
NOTE: Rotate the snap ring to check for proper installation.
12. Apply the specified grease to the dust cover.