Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Trailing Arm: Service and Repair
A: REMOVAL
1. Loosen the rear wheel nuts.
2. Jack-up the vehicle, support it with safety stands (rigid racks) and remove the rear wheels.
3. Remove both rear parking brake clamp and ABS sensor harness. (Models equipped with ABS)
4. Remove the bolt, which secures trailing link to trailing link bracket.
5. Remove the bolt, which secures trailing link to rear housing
B: INSTALLATION
Install in the reverse order of removal.
CAUTION: Always tighten the rubber bushing location when wheels are in full contact with the ground and vehicle is at curb weight condition.
NOTE: Check the wheel alignment and adjust if necessary.
C: DISASSEMBLY
1. FRONT BUSHING
Using ST, press the front bushing out of place.
ST 927720000 INSTALLER & REMOVER SET
2. REAR BUSHING
1. Remove the housing.
