Impreza 2.5 RS Sedan AWD F4-2.5L SOHC (2002)
Dropping Resistor: Service and Repair
A: REMOVAL
NOTE: The dropping resister is only equipped to Non-turbo models.
1. Disconnect the ground terminal from battery.
2. Remove the air intake duct.
3. Disconnect the connector from dropping resistor.
4. Remove the dropping resistor.
B: INSTALLATION
1. Install in the reverse order of removal.
Tightening torque: 6.4 Nm (0.65 kgf-cm, 4.7 ft. lbs.)
