Impreza Brighton Coupe AWD F4-2.2L SOHC (1997)
Air Bag Harness: Service and Repair
Main Harness
Main Harness
REMOVAL AND INSTALLATION
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until main harness are securely re-installed.
4. Disconnect airbag connector (AB9) and (AB10).
5. Remove instrument panel console.
6. Disconnect 12-pin yellow connector (AB6) from airbag control module.