Impreza Brighton Coupe AWD F4-2.2L SOHC (1997)
6. Installation of 1-2 shifter fork and rod
a. Install 1-2 fork rod into 1-2 shifter fork via the hole on the rear of transmission case.
b. Align the holes in rod and fork, and drive straight pin (6 x 22) into these holes using ST.
ST 398791700 Straight Pin Remover, or equivalent.
NOTE:
^
Set other rods to neutral.
^
Make sure interlock plunger (5.56 x 19.6) is on the 3-4 fork rod side.
7. Installation of 3-4 shifter fork if and rod
a. Install interlock plunger (3 x 11.9) onto 3-4 fork rod.
CAUTION: Apply a coat of grease to plunger to prevent it from falling.
b. Install 3-4 fork rod into 3-4 shifter fork via the hole on the rear of transmission case.
c. Align the holes in rod and fork, and drive straight pin (6 x 22) into these holes.
ST 398791700 Straight Pin Remover, or equivalent.
NOTE:
^
Set reverse fork rod to neutral.
^
Make sure interlock plunger (installed before) is on the reverse fork rod side.
8. Install 5th shifter fork (16) onto the rear of reverse fork rod (6). Align holes in the two parts and drive straight pin into place.
ST 398791700 Straight Pin Remover, or equivalent.
9. Position balls (17), checking ball springs (18) and gaskets (19) into 3-4 and 1-2 rod holes, and install plugs (20).
CAUTION: Replace gasket with a new one.
10. Installation of speedometer driven gear