Impreza Brighton Coupe AWD F4-2.2L SOHC (1997)
3. Mount each parts (Boot, O-ring, bush and spacer) on the gearshift lever.
CAUTION:
-
Always use new O-rings.
-
Apply grease [NIGTIGHT LYW No.2 or equivalent] to the inner and side surfaces of the bush when installing spacer.
4. Insert the gearshift lever into the boot hole.
5. Mount gearshift lever on the stay.
6. Install snap ring to the bottom of the bush (Stay rear).
7. Tighten with locking wire to the extent that the boot will not come off.
CAUTION: Always use new locking wire.
8. Insert the rod into the boot hole.
9. Connect rod to gearshift lever.
Tightening torque:
12 +/- 3 Nm (100.4 +/- 26.4 inch lbs.).
Rocking torque:
0.74 +/- 0.25 Nm (6.48 +/- 2.16 inch lbs.) or less
10. Check that there is no excessive play and that parts move smoothly.