subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Front Disc Brake|Page 3149 > < Tightening Torque|Page 3146
Page 1
background image

Brake Caliper: Service and Repair
Front Disc Brake

On-Car Service

PAD 

1) Remove lock pin.
2) Raise caliper body.
3) Remove pad.

4) Check pad thickness A.

CAUTION: 
-

Always replace the pads for both the left and right wheels at the same time. Also replace pad clips if they are twisted or worn.

-

A wear indicator is provided on the inner disc brake pad. If the pad wears down to such an extent that the end of the wear indicator
contacts the disc rotor, a squeaking sound is produced as the wheel rotates. If this sound is heard, replace the pad.

-

Replace pad if there is oil or grease on it.

5) Apply thin coat of PBC GREASE (Part No.003607000) to the frictional portion between pad and pad clip.
6) Install pads on support.
7) Install caliper body on support.

NOTE:  If it is difficult to push piston during pad replacement, loosen air bleeder to facilitate work.

Front Disc Brake|Page 3149 > < Tightening Torque|Page 3146