Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
Control Assembly: Service and Repair
Control Unit
REMOVAL
1. Disconnect GND cable from battery.
2. Set temperature control switch (1) to "FULL COLD" and mode selector switch 0(2) to "DEF" position.
3. Remove temperature control cable and mode door control cable from heater unit.
NOTE:
-
Do not attempt to move links during installation.
-
Before control unit installation, set temperature control switch to "FULL COLD" and mode selector switch to "DEF" position.
4. Remove center panel.
5. Remove control unit assembly and disconnect connector.
INSTALLATION
Installation is in the reverse order of removal.