Impreza Coupe FWD F4-1820cc 1.8L SOHC (1995)
To assemble, reverse order of disassembly.
1. Pulling up brush
Before assembling, press the brush down into the brush holder with your finger and secure in that position by passing a [2 mm (0.08 in) dia. length
4 to 5 cm (1.6 to 2.0 in)] wire through the hole shown in the figure.
CAUTION: Be sure to remove the wire after reassembly
2. Heat the rear bracket [50 to 60 °C (122 to 140 °F)] and press the rear bearing into the rear bracket. Then lubricate the rear bracket.
3. After reassembly, turn the pulley by hand to check that the rotor turns smoothly.
