Impreza GT F4-2.5L Turbo (2009)
CAUTION:
Be careful not to allow foreign matter to enter into inspection hole.
11) Align the center of roll connector.
12) Apply the grease provided with the new part on the 4 locations of the protrusion on the steering angle sensor.
13) Align the position of the protrusion and install roll connector to steering angle sensor.
Tightening torque:
0.5 Nm (0.05 kgf-m, 0.36 ft-lb)
14) Install the roll connector to combination switch and bind the harness with vinyl tape as originally bound.
