Impreza GT F4-2.5L Turbo (2009)
9) Place the rib surface of the rear side belt into the crank pulley groove, so that the rear side belt comes in between the belt guide holder.
CAUTION:
When it is difficult to place the rear side belt to the crank pulley groove, pull out the belt guide holder half way, then place the rear side belt
into the groove so that it comes in between the belt guide holder.
10) Place the tool through the loop of the rear side belt, and set on the crank pulley bolt.
11) While checking the following, slowly turn the crank pulley approximately 90° clockwise so that the belt guide comes to the position shown in the
figure.
CAUTION:
When turning the crank pulley, always make sure that the belt guide is not off from the crank pulley groove.
