Impreza GT F4-2.5L Turbo (2009)
-
When painting or performing sheet metal work on the front part of the vehicle, including the front wheel apron, front fender and front side frame,
remove the front sub sensors and wiring harness of airbag system.
-
When painting or performing sheet metal work on the side of the vehicle or rear floor pan, around rear crossmember, including the side sill, center
pillar and front and rear doors, remove the side airbag sensors, curtain airbag sensor, satellite safing sensor and wiring harness of the airbag
system.
-
Do not use the airbag or pretensioner parts from other vehicles. Always replace the defective parts with new parts.
-
Never reuse a deployed airbag module and pretensioner.
-
Do not discard the uninflated airbag or pretensioner.
-
When airbag control module, front sub sensor, side airbag sensor, curtain airbag sensor and satellite safing sensor are removed, do not reuse the
bolts and nuts of them. Always use new bolts and nuts for them.
-
Do not drop each airbag module, airbag control module and each sensor, or store these parts under high temperature of 85 °C (185 °F) or more, or
let water, oil or grease get on them; the internal parts may be damaged or the reliability may be greatly lowered.
-
After removal of each parts for airbag system, keep them with the pad facing upward on a dry, clean and flat surface without heat, light sources,
moisture and dust.
