Impreza GT F4-2.5L Turbo (2009)
Air Bag Control Module: Service and Repair
Airbag Control Module
REMOVAL
CAUTION:
-
Do not disassemble the airbag control module.
-
If the airbag control module is deformed or if the damage from water is suspected, replace the airbag control module with a new part.
-
Do not drop the airbag control module.
-
After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the console box.
4. Remove the center panel.
5. Remove the console front panel.
6. Remove the audio.
7. Remove the heater duct.
8. Disconnect the connector from airbag control module.
9. Remove the three bolts and remove airbag control module.
INSTALLATION
CAUTION:
-
Do not reuse the bolt and nut. Always use new bolts and nuts for them.
-
Before installing the audio, make sure that the heater duct is securely connected.
Install in the reverse order of removal.
Tightening torque: 25 N.m (2.55 kgf.m, 18.4 ft.lb)