Impreza GT F4-2.5L Turbo (2009)
Impact Sensor: Service and Repair
Front Sub Sensor
Front Sub Sensor
REMOVAL
1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the front bumper face.
4. Remove the headlight assembly.
5. Remove the bolt, and then detach the front sub sensor.
6. Disconnect the connector from front sub sensor.
INSTALLATION
CAUTION:
-
Do not reuse the bolt and nut. Always use new bolts and nuts for them.
-
When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
-
After the installation of headlight assembly, be sure to perform headlight beam adjustment.
Install in the reverse order of removal.
Tightening torque: 13 N.m (1.33 kgf.m, 9.6 ft.lb)
