Impreza GT F4-2.5L Turbo (2009)
ST2 28099PA110 AXLE SHAFT PULLER PLATE
Installation
INSTALLATION
1) Aligning with the mounting hole of the rear brake back plate, temporarily tighten the rear hub unit bearing to the rear housing.
CAUTION:
^
Be careful not to damage the magnetic encoder.
^
Do not get closer the tool which charged magnetism to magnetic encoder.
2) Tighten the four bolts of the rear housing.
Tightening torque:
65 N-m (6.6 kgf-m, 47.9 ft-lb)
3) Tighten the new axle nut temporarily.
CAUTION:
Use new axle nuts.
4) Install the rear disc rotor. (Disc brake model)
5) Install the rear brake drum. (Drum brake model)
6) Install the disc brake caliper on the rear housing.
(Disc brake model)