Impreza GT F4-2.5L Turbo (2009)
Clutch Master Cylinder: Service and Repair
Master Cylinder
REMOVAL
1) Thoroughly drain the brake fluid from the reservoir tank.
2) Remove the snap pin and clevis pin, and then separate the push rod of the master cylinder from clutch pedal.
3) Remove the air intake chamber. (Non-turbo model)
4) Remove the intercooler. (Turbo model)
5) Remove the clutch pipe from the master cylinder.
6) Remove the master cylinder and reservoir tank as a unit.
CAUTION:
Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe
clean quickly if spilled.
INSTALLATION
1) Install the master cylinder to the vehicle body, and connect the clutch pipe to the master cylinder.
NOTE:
Check that the pipe is routed properly.
Tightening torque:
T1: 15 N-m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N-m (1.8 kgf-m, 13.3 ft-lb)