Impreza GT F4-2.5L Turbo (2009)
Hydraulic Hose: Service and Repair
Clutch Pipe and Hose
REMOVAL
1) Remove the air intake chamber. (Non-turbo model)
2) Remove the intercooler. (Turbo model)
3) Drain the clutch fluid.
4) Disconnect the clutch pipe from the clutch hose and master cylinder.
5) Pull out the clamp, then disconnect the clutch hose from the bracket.
6) Remove the hose from operating cylinder.
7) Remove the bracket.
INSTALLATION
Install in the reverse order of removal.
NOTE:
^
The illustration below is suitable for every model. Perform the same procedures for the other models. Bleed air from the clutch fluid.
Tightening torque:
T1: 15 N-m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N-m (1.8 kgf-m, 13.3 ft-lb)
T3: 25 N-m (2.5 kgf-m, 18.4 ft-lb)