Impreza L Sedan F4-2.2L SOHC (1997)
2. Remove piston, cup, spring and air bleeder screw and cap.
(1) Bleeder cap
(2) Bleeder screw
(3) Spring
(4) Cylinder
(5) Cup
(6) Piston
(7) Boot
ASSEMBLY
1. Clean all parts in brake fluid. Check and replace faulty parts.
-
Cup and boot for damage or fatigue.
-
Cylinder, piston and spring or damage or rust formation.
2. Assembly is the reverse order of disassembly.
(1) When installing the cup, use Special Tool (ST), apply brake fluid to the frictional surface for smooth installation and pay attention to cup
direction.
(2) STs are available in different sizes.
CAUTION:
^
When replacing the repair kit, make sure that the sizes of cylinder and cup are the same as those which were replaced.
^
Use only the tool of the correct size.
^
While assembling, be careful to prevent any metal chip, dust or dirt from entering the wheel cylinder.