Impreza L Sedan F4-2.2L SOHC (1997)
Brake Pressure Hold Valve: Service and Repair
REMOVAL
1.
Drain primary side of master cylinder.
2.
Remove cable adjusting nut and clamp from clutch release bearing fork, then disconnect cable from engine bracket.
3.
Remove cable from PHV.
4.
Separate connector bracket from PHV, then remove brake lines using a suitable flare wrench.
5.
Remove PHV bracket to frame retaining bolts and the PHV. Do not allow any dirt to enter PHV.
INSTALLATION
To install, reverse removal procedure, noting the following:
1.
Apply lubricant to hooked portion of return spring, cable end of lever and cable end at clutch release bearing fork.
2.
Bleed brakes after installation.