Impreza L Sport Wagon F4-2.2L SOHC (1999)
4. Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
5. Remove instrument panel console.
6. Disconnect connector from airbag control module.
7. Using T40 TORX® bit (Tamper resistant type), remove four TORX® bolts in numerical sequence shown in figure. Discard the old TORX® bolts.
CAUTION: Use new TORX® bolts during re-assembly.
8. Installation is in the reverse order of removal.
