subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Front Suspension|Page 559 > < Front Suspension|Page 557
Page 3
background image

3. Tighten the two self-locking nuts.

Tightening torque: 152 Nm (15.5 kgf-m, 112 ft. lbs.) 

WHEEL TOE-IN 

^

Inspection 

1. Using a toe-in gauge, measure rear wheel toe-in.

Toe-in: 0 ± 3 mm (0 ± 0.12 inch) 

2. Mark rear sides of left and right tires at height corresponding to center of spindles and measure distance "B" between marks.
3. Move vehicle forward so that marks line up with front sides at height corresponding to center of spindles.
4. Measure distance "A" between left and right marks. Toe-in can then be obtained by the following equation:

B - A = Toe-in 

^

Adjustment 

1. Loosen self-locking nut on inner side of rear lateral link.

CAUTION: 
^

When loosening or tightening adjusting bolt, hold bolt head and turn self-locking nut.

^

Discard loosened self-locking nut and replace with a new one.

Front Suspension|Page 559 > < Front Suspension|Page 557