Impreza L Sport Wagon AWD F4-2.2L SOHC (2001)
NOTE: Apply specified power steering fluid to outer diameter surface of input shaft and outer surface of valve body seal ring, and pay special
attention not to damage seal when inserting pinion and valve assembly.
6. Secure valve assembly to ST1 and ST2.
7. Put ST3 over pinion, and insert oil seal, then force-fit oil seal into housing using ST4.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
NOTE:
^
Apply specified power steering fluid to oil seal and ST3, being careful not to damage oil seal lip.
^
Push oil seal until ST3 contacts housing end face.
8. Remove ST3, and fit backing washer.
9. Force-fit ball bearing using ST3.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 927640000 INSTALLER B
NOTE: Be careful not to tilt ball bearing during installation.
10. Install snap ring using snap ring pliers.
NOTE: Rotate snap ring to check for proper installation.
Rack Housing Oil Seal