Impreza L Sport Wagon AWD F4-2.2L SOHC (2001)
6. Draw out spring pin, then remove bush (Shift lever) from lever.
D: ASSEMBLY
1. Clean all parts before assembly.
2. Mount the following parts on the stay.
3. Mount each parts (Boot, O-ring, bush and spacer) on the gearshift lever.
CAUTION:
^
Always use new O-rings.
^
Apply grease [NIGTIGHT LYW No. 2 or equivalent] to the inner and side surfaces of the bush when installing spacer.
4. Insert the lever into the boot hole.
5. Mount lever on the stay.
6. Install snap ring to the bottom of the bush (Stay rear).