Impreza L Sport Wagon AWD F4-2.2L SOHC (2001)
CAUTION: Be careful not to damage body finish.
2. Cleaning of body surface:
1. Remove chips, dirt and dust from body surface.
2. Clean body wall surface and upper surface of adhesive layer with a solvent such as alcohol or white gasoline.
3. Cleaning glass:
1. Remove dirt and dust from surface of glass to be adhered.
2. Clean surface of glass to be adhered with alcohol or white gasoline.
4. Application of primer:
1. Using a sponge, apply primer to surface of glass to be adhered.
2. Apply primer to surface of body to be adhered.
CAUTION:
-
If primer has dropped on body finish, it is hard to wipe it off. So protect with masking.
-
Primer must not project from black frame of glass.
-
After applying primer, let it dry spontaneously for about 10 minutes.
5. Application of adhesive:
1. Cut nozzle tip as shown in figure.
2. Open cartridge and put it into a gun with nozzle attached.
3. Apply adhesive uniformly to all sides of adhesion surface while operating gun along glass end face.
6. Installation of glass:
1. Hold glass with rubber suction cups.