Impreza Outback Sport AWD F4-2.5L SOHC (2002)
4) Position the disc in straight-forward direction and route the brake hose through hole in bracket on wheel apron side.
CAUTION: Be sure the brake hose is not twisted.
5) Temporarily tighten the flare nut to connect brake pipe and hose.
6) Fix the brake hose with clamp at wheel apron bracket.
7) While holding the hexagonal part of brake hose fitting with a wrench, tighten the flare nut to the specified torque.
Tightening torque (Brake pipe flare nut):
15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
8) Bleed air from the brake system.
2. REAR BRAKE HOSE
1) Pass the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake hose.
2) Insert the clamp upward to fix brake hose.
3) While holding the hexagonal part of brake hose fitting with a wrench, tighten the flare nut to the specified torque.
Tightening torque (Brake pipe flare nut): 15 Mm (1.5 kgf-m, 10.8 ft. lbs.)
4) Bleed air from the brake system.