Impreza Outback Sport AWD F4-2.5L SOHC (2002)
3. Tighten the two self-locking nuts.
Tightening torque: 175 Nm (17.8 kgf-m, 129 ft. lbs.)
3. CASTER
^
Inspection
1. Place the front wheel on turning radius gauge. Make sure the ground contacting surfaces of front and rear wheels are set at the same height.
2. Set the ST into the center of the wheel, and then install the wheel alignment gauge.
ST 927380002 ADAPTER
NOTE: Refer to the "SPECIFICATIONS" for the caster values.
4. FRONT WHEEL TOE-IN
^
Inspection
1. Using a toe gauge, measure the front wheel toe in.
Toe-in: 0 ±3 mm (0 ±0.12 inch)
2. Mark the rear sides of left and right tires at height corresponding to the center of spindles and measure distance "A" between marks.
3. Move the vehicle forward so that the marks line up with front sides at height corresponding to the center of spindles.
4. Measure the distance "B" between left and the right marks. Toe-in can then be obtained by the following equation:
A - B = Toe-in