Impreza RS Coupe AWD F4-2.5L SOHC (1999)
9. Removing three retaining screws, remove combination switch.
CENTERING ROLL CONNECTOR
Before installing steering wheel, make sure to center roll connector built into combination switch.
INSTALLATION
CAUTION: failure to do this might damage roll connector.
1. Before installing combination switch, check to ensure that combination switch is off and front wheels are set in the straight ahead position.
2. Install column cover and center roll connector.
3. Install steering wheel in neutral position. Carefully insert roll connector pin (A) into hole on steering wheel.
NOTE: If steering wheel angle requires fine adjustment, adjust tie-rod.
4. Install airbag module and lower cover in the reverse order of removal.