Impreza Sedan AWD F4-1820cc 1.8L SOHC (1993)
Impact Sensor: Service and Repair
Front Sensor
CAUTION:
-
If the front end of the vehicle body is damaged by a collision, be sure to check the left and right front sensors, even if the airbag was not inflated. If
any damage to the sensor or any deformation of the sensor mount is found, replace with a new genuine part.
-
When painting or performing sheet metal work on the front part of vehicle body, including the front wheel apron, front fender and front side frame,
take utmost care not to apply dryer heat, painting mist, or the flame of the welding burner directly to the front sensors and wire harness of the
airbag system.
REMOVAL
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until front sensors are securely re-Installed.