Impreza Wagon AWD F4-1820cc 1.8L SOHC (1993)
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
4. Remove instrument panel console.
5. Disconnect 12-pin yellow, 2-pin blue and 2-pin orange connectors from airbag control module.
6. Using 130 TORX(R) bit (Tamper resistant type), remove four TORX(R) bolts in numerical sequence shown in figure. Discard the old TORX(R)
bolts.
CAUTION: Use new TORX(R) bolts during re-assembly.
INSTALLATION
Installation is in reverse order of removal procedures.
CAUTION: Be sure to fully secure all airbag system connectors during re-assembly and confirm that all green double lock mechanisms are engaged.